Eel md last step
Jump to navigation
Jump to search
eel_md_last_step sets the value of last MD step of a previous run. It is used only in case of restarting a simulation. This value is used while writing data to the electronic energy transfer output file, ElectronicEnergyLoss.txt.
Summary
| Required/optional | Type | Accepted values | Default | See also | Remarks |
|---|---|---|---|---|---|
| Optional | Integer | 100, 1000, etc. | 0 | eel_E_prev_time, eel_md_prev_time
|
If previous run was up to 1000 steps, use 1000 here. |
